Analogue Impact Testing Machine Manufacturers in India
Analogue Impact Testing Machine
We at TestCraft are Manufacturer, Supplier, Exporter of Analogue Impact Testing Machine, Digital Impact Testing Machine. Our setup is situated in Ichalkaranji, Maharashtra, India and majorly we serve customers from African and Gulf countries.
Technical Specifications
- Capacity : Charpy : 300 Joule, Izod: 170 Joule
- This is low cost Impact testing machine & it is specially de766-1977, IS 15signed for engineering colleges.
- This Machine conforms to IS 3766-1977, IS 1598-1977, IS 1757-1988,IS 1499-1977 and BS 131 Part I, II, III, IV. standard.
- This is simple and maintenance free machine.
- New modified Brake drum unit is provided to stop the pendulum swing instantly after test.
- Safety guard is provided for operator safety.
General Description
The pendulum is mounted on antifriction bearings. It has two starting positions, the upper one for Charpy the lower one for Izod testing. On release, the pendulum swings down to break the specimen & the energy absorbed in doing so is measured as the difference between the height of drop before rupture of the test specimen and is read from the maximum pointer position on the dial scale. (It is read on the digital readout in case of electronic machines). There are two strikers and one combined support anvil available for fitting into the pendulum and on the base of the machine for the Izod, Charpy test respectively. Changing from one striker to another is achieved simply by fixing the new striker into its position.
Standard Accessories
- ⮚ Charpy Striker R2 mm - 1No.
- ⮚ Izod Strike R0.75 mm - 1No.
- ⮚ Charpy - Izod support Block - 1No.
- ⮚ Specimen setting Gauges for Charpy & Izod - l Each.
- ⮚ Allen key Set - 1 set.
- ⮚ Instruction Manual - 1 No.
Charpy Test
The Charpy test piece rests on alloy steel support anvils, fitted on the base of the machine rigidly held in position by Allen screws. An end stopper is provided for quickly and accurately locating the test piece centrally between the supports.
Izod Test
The Izod test piece is clamped vertically in Izod support fitted on the base of the machine. The support is provided with a machined vertical groove to suit the test piece size. The front clamp piece and the Allen screw enable clamping of the test piece incorrect height with the help of the Izod setting gauge supplied.